Reloading Equipment Berger .224 75g VLD Target Bulk
- By Grand
- Buy - Sell - Trade
- 1 Replies
-
Having trouble using the site?
Contact support
Posts
Training Courses Mid Range Gas Gun Course| Sanford, NC| January 11-12
- Training Course Announcements
- 3 Replies
The Mid-Range Gas Gun Course is a hands-on, skill-building course designed for shooters who want to develop their skills with semi-automatic rifles. This course focuses on engaging targets at mid-range distances (100-600 yards) using the AR-15 or similar platforms. This course will provide you with the tools and techniques needed to increase your accuracy, confidence, and speed while shooting at extended ranges.
Held at a private range
For more information email [email protected] or PM.
www.gldperformance.com
Held at a private range
For more information email [email protected] or PM.
Mid-Range Gas Gun Course | G.L.D Performance
course designed for shooters who want to develop their skills with semi-automatic rifles. This course focuses on engaging targets at mid-range distances (100-600 yards) using the AR-15 or similar platforms. This course will provide you with the tools and techniques needed to increase your...
www.gldperformance.com
Attachments
Firearms Nighthawk Custom Shadow Hawk 9mm Double stack w/ IOS plate
- By dms416
- Buy - Sell - Trade
- 5 Replies
Some minor finish wear on the front edge of the slide, but otherwise excellent condition. Not the first owner; picked this up on 1911addicts this past summer and need to thin the herd.
Austin Lehr build from April 2023
Shadow Hawk Double stack 9mm
New "aggressive" grip texture
Gold bead front sight
Flush fit/recessed slide stip
Barrel flush with barrel bushing
Ambi safety
Flat trigger
Heinie tritium rear (will also include new, plain black Heine rear) IOS
Trijicon RMR/Holosun IOS plate included
Full-length guide rod and flat recoil spring setup (will come with guide rod for regular springs)
Includes 2x 17-round mags and I'm throwing in a new maglula loader.
Asking $4700 shipped UPS air to FFL
Discreet paypal gift, Zelle.
Not looking for trades
Austin Lehr build from April 2023
Shadow Hawk Double stack 9mm
New "aggressive" grip texture
Gold bead front sight
Flush fit/recessed slide stip
Barrel flush with barrel bushing
Ambi safety
Flat trigger
Heinie tritium rear (will also include new, plain black Heine rear) IOS
Trijicon RMR/Holosun IOS plate included
Full-length guide rod and flat recoil spring setup (will come with guide rod for regular springs)
Includes 2x 17-round mags and I'm throwing in a new maglula loader.
Asking $4700 shipped UPS air to FFL
Discreet paypal gift, Zelle.
Not looking for trades
SOLD SOLD: Arken EP5 5-25 VPR MIL
- By db2000
- Buy - Sell - Trade
- 10 Replies
ALL SCOPES SOLD
Still have a set of MKM caps and parallax wheel. $75
Arken EP5 5-25 VPR MIL
I have several available. These are excellent scopes for this price. They excel far beyond many other scopes in the sub $1000 price range. All scopes and glass are in excellent shape. Turrets are solid and parallax matches to distances. My feedback is stellar, so rest assured these are as I say they are.
I’m thinning the herd of scopes not in use.
No trades. Price is firm.
$400 PPFF or add 4%.
Can include MKM parallax wheel, mag throw lever and covers for $75 extra if preferred. $135 value.
Still have a set of MKM caps and parallax wheel. $75
Arken EP5 5-25 VPR MIL
I have several available. These are excellent scopes for this price. They excel far beyond many other scopes in the sub $1000 price range. All scopes and glass are in excellent shape. Turrets are solid and parallax matches to distances. My feedback is stellar, so rest assured these are as I say they are.
I’m thinning the herd of scopes not in use.
No trades. Price is firm.
$400 PPFF or add 4%.
Can include MKM parallax wheel, mag throw lever and covers for $75 extra if preferred. $135 value.
Accessories Vortex Precision Matched Rings 34mm 1.26”
- By 981kirk
- Buy - Sell - Trade
- 7 Replies
Excellent condition. Had a Kahles 525i 5-25x56 mounted in it.
$125 shipped.
Call or text for questions 615-866-8036
$125 shipped.
Call or text for questions 615-866-8036
Firearms FS: Unfinished AR10
- Buy - Sell - Trade
- 9 Replies
Selling my SLR B36 LFAR and accessories, need to get stuff out of the house that I don't use.
SLR B36 upper and lower has a wilson combat 2 stage trigger, Radian 45/90 safety, mag and bolt release installed $400
SLR zro 15in mlok rail $125 -Sold
SLR .875 adj gas block with nitrided rifle length tube $100
Cryptic coating black mystic bcg $250 Sold
Armaspec victory charging handle $50
Paypal or cash in person (Michigan residents)
SLR B36 upper and lower has a wilson combat 2 stage trigger, Radian 45/90 safety, mag and bolt release installed $400
SLR zro 15in mlok rail $125 -Sold
SLR .875 adj gas block with nitrided rifle length tube $100
Cryptic coating black mystic bcg $250 Sold
Armaspec victory charging handle $50
Paypal or cash in person (Michigan residents)
Reloading Equipment FS: Hornady .223 seating die
- Buy - Sell - Trade
- 1 Replies
Selling my hornady custom grade .223 seating die. I have too much stuff in the house and need to get rid of things I don't use. Comes in the original plastic holder.
Asking $25
Asking $25
Piggyback Red Dot Mount
- Observation & Sighting Devices
- 8 Replies
The T-Rex Arms offset Aimpoint mount I had wasn't really working for me on my SPRecce with the NF 4-16 ATACR. So I started looking at some different solutions, an Arisaka offset mount was one of them but I also wanted to give a piggy back mount another go. The trouble was that the two 34mm options I found were $150-$170 which was a bit much for something I may not even like. However, I found a cheap option on Amazon, a Monstrum 34mm piggyback picatinny mount for a whopping $21.
This isn't a review so much as my observations, for being a MIC product the quality isn't bad, the finish is consistent, the fasteners appeared to be good enough, even the small screws holding the rail to the ring cap. I had about 1" from the front of the ring to the start of the objective bell and this mount fit perfectly in between, I'd say it's probably .90" or so wide. There are two mounted positions for the rail so it can be biased toward the front or the rear towards the turret. On my set up, having it biased towards the rear was too close to the turret for me but forward put it a bit close to the objective bell so I filed it down for more clearance.
Height from scope center to top of the picatinny is about 1 3/8", which puts the Sig 2" above scope center line with the low mount as shown. I zeroed it at 100 yards without any drama and it stayed put throughout the range trip so I'll chalk that up to a win in my book. I have to say the 12:00 set up is growing on me but I think I'd like something where the red dot is more directly mounted instead of a series of fasteners so I might start giving the LT787 and Reptilia options a closer look.
The HOB above and zeroed at 100 yards means that of course I need to hold high A-Zone inside of 50 yards but I'm basically a dead hold from there until about 200+ yards and at 300 I'd be holding about the shoulder line on a BC plate.
This isn't a review so much as my observations, for being a MIC product the quality isn't bad, the finish is consistent, the fasteners appeared to be good enough, even the small screws holding the rail to the ring cap. I had about 1" from the front of the ring to the start of the objective bell and this mount fit perfectly in between, I'd say it's probably .90" or so wide. There are two mounted positions for the rail so it can be biased toward the front or the rear towards the turret. On my set up, having it biased towards the rear was too close to the turret for me but forward put it a bit close to the objective bell so I filed it down for more clearance.
Height from scope center to top of the picatinny is about 1 3/8", which puts the Sig 2" above scope center line with the low mount as shown. I zeroed it at 100 yards without any drama and it stayed put throughout the range trip so I'll chalk that up to a win in my book. I have to say the 12:00 set up is growing on me but I think I'd like something where the red dot is more directly mounted instead of a series of fasteners so I might start giving the LT787 and Reptilia options a closer look.
The HOB above and zeroed at 100 yards means that of course I need to hold high A-Zone inside of 50 yards but I'm basically a dead hold from there until about 200+ yards and at 300 I'd be holding about the shoulder line on a BC plate.
Firearms Compensated, Red dot, Marvel-style 2011 9mm from Guardian Arsenal
- By dms416
- Buy - Sell - Trade
- 0 Replies
4.75" length designed to shoot +P ammo with the same feeling as standard pressure out of a 5" gun. Built by one of the 2 shops (the other being NHC) that offers a Marvel signature gun by name. Built to Marvel building spec numbers.
Cheely Frame
JEM slide
EGW single port cone comp with bull nose contour
Kensight front with hi-vis yellow/tritium front
modified Glock rear
Type 2 RMR 3.25moa in a modified Trijicon mount
KART 9mm match barrel
Reverse plug bushing, full length guide rod, flat wire recoil spring
MJD Grip housing by Extreme
Everglades de-horned flat trigger (about 3lbs)
Superb gun, insanely accurate and flat shooting over 3000-3400 rounds (most were and standard, non-+P rounds).
$5000 shipped and includes the RM06 (3.25moa) type 2 RMR , 1x 17-round mag.
Discreet paypal gift, Zelle for payment
NO TRADES
Cheely Frame
JEM slide
EGW single port cone comp with bull nose contour
Kensight front with hi-vis yellow/tritium front
modified Glock rear
Type 2 RMR 3.25moa in a modified Trijicon mount
KART 9mm match barrel
Reverse plug bushing, full length guide rod, flat wire recoil spring
MJD Grip housing by Extreme
Everglades de-horned flat trigger (about 3lbs)
Superb gun, insanely accurate and flat shooting over 3000-3400 rounds (most were and standard, non-+P rounds).
$5000 shipped and includes the RM06 (3.25moa) type 2 RMR , 1x 17-round mag.
Discreet paypal gift, Zelle for payment
NO TRADES
Firearms 1903a4 Clone.
- By MTAR15
- Buy - Sell - Trade
- 0 Replies
Selling a 1903a4 sniper clone(ish) rifle. Has a standard a3 action instead of the canted roll mark.
The action is 1903a3 with a new criterion barrel installed, test fired only.
Timney trigger installed
Correct weaver 330 M8 scope with tapered post. The scope was completely overhauled and is crystal clear.
Asking $1800 shipped in CONUS
I also have ammo in sealed spam can that I would be willing to sell to the rifle buyer only.
The action is 1903a3 with a new criterion barrel installed, test fired only.
Timney trigger installed
Correct weaver 330 M8 scope with tapered post. The scope was completely overhauled and is crystal clear.
Asking $1800 shipped in CONUS
I also have ammo in sealed spam can that I would be willing to sell to the rifle buyer only.
Optics ** price reduced** WTS- leupold BX-5 Santiam HD 15x56
- By Trippm
- Buy - Sell - Trade
- 16 Replies
Attachments
Accessories Surefire Socom 338 TI suppressor $1500
- By 300blk10.5
- Buy - Sell - Trade
- 0 Replies
Attachments
Optics Relist: better pics. V.tex 4.5-27 RazOR HD 2, ILLUM. MOA, FFP.
- By TresMon
- Buy - Sell - Trade
- 10 Replies
Relisting this optic. I borrowed a nice camera and took better photos.
Vortex 4.5-27 Razor HD II
Illuminated, FFP
MOA: EBR-2c reticle.
Original box.
Included: Vortex HD Precision picatinny/ Weaver style rings: Low mount.
& Vortex fast throw lever on zoom/power ring.
$1325, OR best offer. Make me an offer.
Vortex 4.5-27 Razor HD II
Illuminated, FFP
MOA: EBR-2c reticle.
Original box.
Included: Vortex HD Precision picatinny/ Weaver style rings: Low mount.
& Vortex fast throw lever on zoom/power ring.
$1325, OR best offer. Make me an offer.
