• HideTV Updates Coming Monday

    HideTV will be down on Monday for updates. We'll let you all know as soon as it's back up and message @alexj-12 with any questions!

  • Win an RIX Storm S3 Thermal Imaging Scope!

    To enter, all you need to do is add an image of yourself at the range below! Subscribers get more entries, check out the plans below for a better chance of winning!

    Join the contest Subscribe

Gunsmithing Atlas Bipod Question

Yeah.....its a 17S hole pattern which, while its become somewhat defacto, was published by ADM and is used widely.

Are we misunderstanding something here?


1712163987696.png


1712164120605.png
 
Last edited:
  • Like
Reactions: Part Timer
Unless I’m missing something

He has this model, not one set up for the ADM-170 adapter:

1712163950023.png

I would say the most expeditious route to take is a get an ADM QD low riser and mount this to it, use threadlocker on the screws, and make it semi-permanent.


ETA: After reading the FAQ's on the Accu Shot website pertaining to this issue, sending it back to them to have the conversion done doesn't seem like too bad a deal. It sounds like they'll straight up exchange it or convert yours for a nominal fee, less than the cost of the AD-170 mount.
 
Last edited:
  • Like
Reactions: Part Timer