Hi all, does anyone know of an aftermarket adapter to connect an Atlas BT-10 V8 to an ADM-170-S QD lever without sending the bipod back to Atlas for retrofit? Thanks!
Gunsmithing Atlas Bipod Question
- Thread starter Reformedcitykid
- Start date
Yeah.....its a 17S hole pattern which, while its become somewhat defacto, was published by ADM and is used widely.
Are we misunderstanding something here?
Are we misunderstanding something here?
Last edited:
He has this model, not one set up for the ADM-170 adapter:
I would say the most expeditious route to take is a get an ADM QD low riser and mount this to it, use threadlocker on the screws, and make it semi-permanent.
AMERICAN DEFENSE MANUFACTURING AD-170-VPG 5-LUG PICATINNY RISER MOUNT
Check out AMERICAN DEFENSE MANUFACTURING AD-170-VPG 5-LUG PICATINNY RISER MOUNT available Online at Brownells Today and many more Red Dot Mounts products are available in our Optics Department.
www.brownells.com
ETA: After reading the FAQ's on the Accu Shot website pertaining to this issue, sending it back to them to have the conversion done doesn't seem like too bad a deal. It sounds like they'll straight up exchange it or convert yours for a nominal fee, less than the cost of the AD-170 mount.
Last edited:
