Hi all. I am trying to mount a scope as close to the bore as possible on a Winchester M70, 300 WSM. It is a 42 mm objective. I would like to mount it on a rail platform if possible. However, this puts the scope higher than I would like it. Does anyone make a picatinny rail shorter than .38" high? Most of the height of the Picatinny rail seems like wasted space. If there was a much lower profile rail, I could mount low Seekins rings (or something comparable) and get down just as low as I want. Thanks!
Is there a Picatinny rail shorter than .38"?
- Thread starter Quigley76
- Start date
Based on this image https://en.wikipedia.org/wiki/Picatinny_rail#/media/File:M1913A_Rail_CrossSection.svg I'd say no. If you want to get your scope low, you can't do better than an action specific mount.
Want to use these.
.82” to center of ring.
Scope Rings - 30mm Tube
<p>The best rifle scope in the world is useless without scope rings precisely aligned that hold it immovably in place. Seekins Precision Scope Rings are the best available to mount precision optics to precision rifles. Machined from 7075-T6 alum
seekinsprecision.com
Depends on the rifle and the scope. Some can be mounted lower than others. Scopes on ARs with full length rails need taller mounts than scopes on traditional wood stocked bolt action rifles. I don't pay too much attention to it and couldn't tell you- without measuring- what height rings I've used. I use rings tall enough for the bell of the optic to clear the barrel/handguard. Then I adjust my check weld with either a stock adjustment, or by building it up with foam and "vet wrap" or a stock pack.
Ok, the real questions are; "how high is higher than you'd like?,and why is that too high?"Want to use these.
.82” to center of ring.
Scope Rings - 30mm Tube
<p>The best rifle scope in the world is useless without scope rings precisely aligned that hold it immovably in place. Seekins Precision Scope Rings are the best available to mount precision optics to precision rifles. Machined from 7075-T6 alumseekinsprecision.com
I don’t want the scope more than 4-5 mm above the barrel for optimal cheek weld without needing to use additional risers, etc.
The low Talley mounts seem like the best option to mount close to bore. Guess I might have to rethink the importance of a rail set up.
