It's a variation of a mirage ulr chassis, Anvil bipod, can't remember who makes the break, i o r valdata crusader, blueprinted Tac 338 action on the best of three barrels I have. Ibi 34 in chambered with my dies, which are minimum Sammy spec. Jewel, or jim? Can't remember Pro Comp trigger at 0.8 Oz.
My best loads are in Lapua brass, turned and trimmed and uniformed after first firing. 1.5 thou neck tension, 300 grain Hornady atips, and the good loads that I used in the video, that round was ramshot LRT. Just found rotumbo... much excite...
105.5 grains of that LRT, 3044 FPS with an extreme spread of two. Yes, two. Obviously did the entire powder load tuning and overall length tuning. Not that this is relevant to literally anything except for my gun, but I am 26 thou of jam. My Barrel is throated for these 300 grain atips at this length. Magazine capacity is 4.050. Uhhhh... what am I missing? After uniforming primer Pockets I have six thousands of pressure on the CCI 250s. I sort of sort bullets and primers by weight, I just eliminate the extreme 10%. I think that is completely pointless. Not sure though. My powder node is 0. 6 grain wide, loading in the middle of course. My overall length node is 8 thou wide, loading at the top six. I keep my Barrel glass clean. I really never fire more than six or seven between cleanings, I really never fire more than two or three shots on a range day. Unless it's at the actual range, I'll go through like 20 but it gets inconsistent. Make sure to treat with lockease graphite suspended in alcohol after cleaning for no cold bore shift! Obviously also easier to clean. I do not tip the atips, but I do for the 300 grain Burger otm hybrids.
I don't know why you guys want to know these things. As you may or may not know, it is completely rifle specific. None of this data does you any good.