die

  1. J

    Bushing Die Question

    Hello all. I am trying to put together a reloading setup for .308. I am looking at getting a Redding Big Boss 2 and I have questions about the S style bushing dies. When measuring for the bushings, I should use a fired case to take the neck measurement, right? Second, do you guy neck resize or...
  2. H5N1

    Sizing Die?

    I'm getting new dies(been borrowing).It looks like I'm going to go with a Wilson micrometer seating die,what do you like for resizing dies? I didn't see a set for this seating die. Thanks for your time
  3. dragonlvg

    die question

    reloading on a budget!(as in I am usually broke) I have an RCBS press (RC IV) I am going to be reloading for a 454 casull rifle and want to put the factory crimp in the neck. RCBS (as far as I can tell) doesnt offer a factory crimp die, Lee does. will it thread into my RCBS press? any downsides...
  4. M

    Filing on my sizing die???

    Had reloaded rounds that wont fit my chamber ( fired from another rifle previously ) after running through my dillon small base 308 dies. This condition persists even after adjusting so that the press cams over into the die. The cases fit a gauge just fine but not in my match chamber. I...
  5. springer01

    .308 lapua brass and Lee collet neck die

    I just purchased some new .308 lapua brass I was going to run it through my Lee collet neck sizer because some of the cases are dinged around the case mouth. As I started I noticed when the case hits the decap mandrel it sticks and gets rough, some very bad I even smashed the neck of one then I...
  6. C

    Best die $ can buy?

    After 30+ years shooting factory ammo I'm gonna get back into reloading,I have a Bonanza Co Ax press,most dies have been loaned out over hells half acre.I do not mind paying for good hardware once,I chase the "one hole" who makes the very best dies now,Ill be reloading .223rem, .223wssm, .220...
  7. S

    Hornady 6.5 creedmoor die sets???

    I see that hornady has two different grades of reloading dies for the new 6.5 creedmoor. The standard series set is 32 bucks and the new dimension 2 die set id $150. Are the more expensive dies worth the extra monies? Thanks Lee