work

  1. 1

    Photos Team work

    First two are working together. Sort of a before and after. The last one.....well he's on his own.
  2. mike1128

    Advanced Marksmanship Wind Reading..Would this work?

    Was just curious...but would taking some marking tape and adding weight to the end of it just enough to be distinguishable from a 5-10 mph wind and then using a kestrel to measure what the angle is at different speeds. Then sticking it downrange while also looking at the mirage and surrounding...
  3. Rob01

    Gunsmithing Some nice finish work

    Seems like our own Septic Tank has a new site and is offering finishing work. Looks good www.controlledchaosarms.com
  4. R

    Gunsmithing Bolt work by Dan of www.accu-tig.com

    Well after doing a lot of research I had decided to replace the bolt handle on my 700. After seeing a few pictures of threaded handles that broke at the joint & oversized knob I decided to contacted Dan Armstrong of http://www.accu-tig.com/ After a few phone conversations my bolt was off to...
  5. G

    Gunsmithing Smith for work on a dept rifle?

    I have a issued Rem 700P that I would like to have cut back to 20"-22" and have a larger bolt knob installed. My dept is quite liability sensative and is concerned who would perform the work. Is there a smith who would be recommended for this type of work? It would need to be someone who has...
  6. Short-bus

    Reloading benches, and work areas, lets see 'em

    All right, i'm a fairly new poster, however i've lurked for a little while. What i'm asking here is simply to get some ideas for my "gun room" as I call it since I was banished to keep all firearms, hunting, and just about anything "man" related since we started having children. Well i'm...
  7. Anchor Zero Six

    Gunsmithing Hard filler that will work on a magpul grip?

    Want to swap ou the grip on my KAC IWS. Problem is that since they have a sling stud in the receiver the rear take down pin and spring come through the bottom and not from the rear. The MAID grip is the only aftermarket grip that will work with the ambi safety but the take down pin spring fall...