Sidearms & Scatterguns 1911 won't eject..
- Thread starter SouthernGunner
- Start date
Extractor may be broken or needs to be tuned (Bent).
Perhaps these loads are too hot and the extractor is zipping right over the rim but I don't see any marks that would indicate a good grab by the extractor.
Perhaps these loads are too hot and the extractor is zipping right over the rim but I don't see any marks that would indicate a good grab by the extractor.
From the pick, the loads don't look hot. No flat primer and rim looks fine. With that said, go buy a Wilson bullet proof extractor.
I just went and bought some different loads and they shoot fine. All I had at first was some 150 gr Dynamic research rounds and I guess they were too hot. Now I have some Tula 230gr and they shoot good
Kimber?
Measure cartridge rim diameter. Alot of QC is sliding in todays market due to demand. I had this happen once and it turned out to be a manufacturer flaw. Perform a 10-8 and Wilson Extractor test, and adjust as nessessary. Also check for clocking. If it persists or returns in 1k, replace with a Wilson BP unit.
Measure cartridge rim diameter. Alot of QC is sliding in todays market due to demand. I had this happen once and it turned out to be a manufacturer flaw. Perform a 10-8 and Wilson Extractor test, and adjust as nessessary. Also check for clocking. If it persists or returns in 1k, replace with a Wilson BP unit.
