Accuracy International Picture Thread

[FUNCTIONAL]

Having just gone through this:

1. The AW imuns extends too far into the chassis and blocks the use of the small forwardmost skin screw by about 1/4”-1/8”(not really an issue and easy fix if you cut some clearance)
2. The AW imuns is not tapped for QD cups
3. This seems to be back and forth, but a factory AI barrel is not free floated in an AT with the AW imuns because the top piece of the IMUNS ends up clamping down onto the barrel. I had some 2mm spacers 3d printed to fit the form of the IMUNS and no longer have this issue.

Doesnt seem so bad. All 3 sound fairly easily fixed to use the AW IMUNS. Might pick one up if I ever get a clip on in the future before all this is no longer made.

 

[sidetoss20]

Doesnt seem so bad. All 3 sound fairly easily fixed to use the AW IMUNS. Might pick one up if I ever get a clip on in the future before all this is no longer made.

IMUNS were discontinued already.

IMUNS Night Vision Mount

Installs into Accuracy International AW / AWM, AE, Legacy AICS. Replaces the current bipod mounting block and allows the use of clip on night vision devices such as the A/N PVS-22, A/N PVS-24, A/N PVS-27 or other devices like thermal imagers or fusion devices. The IMUNS has a side accessory...

www.sportingservices.co.uk

 

[FUNCTIONAL]

IMUNS were discontinued already.

IMUNS Night Vision Mount

Installs into Accuracy International AW / AWM, AE, Legacy AICS. Replaces the current bipod mounting block and allows the use of clip on night vision devices such as the A/N PVS-22, A/N PVS-24, A/N PVS-27 or other devices like thermal imagers or fusion devices. The IMUNS has a side accessory...

www.sportingservices.co.uk

yup, this is the only place that has em and where I'd end up getting it. making my decision today.

 

[sidetoss20]

yup, this is the only place that has em and where I'd end up getting it. making my decision today.

There is an AT IMUNS on GB right now…. for $1500……

 

[FUNCTIONAL]

There is an AT IMUNS on GB right now…. for $1500……

Duct tape for me....

 

[Watch_this71]

Starting a couple new projects. I just finished putting the IMUNS on my SA chassis.

 

[Fixr]

Remove the 8mm roll pin and bipod stud. With straight blade screwdriver wedged between the spigot and fore end frame (using the round bipod stud opening), push the spigot forward. A rubber disc between the spigot and sling mount holds the sling mount in place and keeps it from rattling.

View attachment 8617139

View attachment 8617140

View attachment 8617141

View attachment 8617142

View attachment 8617143

View attachment 8617144

View attachment 8617145

View attachment 8617146

View attachment 8617147

View attachment 8617148

How did I know you would be the first one to reply to this