AIAT Gradous Replacement Barrel

[mrobles3808]

Thinking about ordering a 308 gradous barrel for my AT and seeing if anyone has one and what you are using for loads. My factory 1-12" Lothar is fantastic but I'm opting for more length and a 1-10" twist at this point.

 

[diverdon]

Why not change over to a more efficent 6.5 mm at the same time. Either the .260R or the 6.5 CM.

 

[mrobles3808]

Why not change over to a more efficent 6.5 mm at the same time. Either the .260R or the 6.5 CM.

I already have a 6.5 barrel

 

[L.R.Novice]

I don't know about Gradous but it's hard to pass up a Patriot Valley Arms prefit for 15% less. That's where I'm going for a 6.5 CM for my AT...someday.

 

[Supersubes]

Of the people talked about here with regard to AI barrels, you cant go wrong with any of them. PVA, mile high, Stuteville, gradous. There are a few others.

 

[digrazir]

I have Gradous 6.5 cm and 260 26 inch barrels which both shoot lights out. My AI factory 12 twist 308 26 inch barrel shoots just as good. I don't think you will gain much by replacing your factory 308 barrel with an after market 308 barrel...Ray

 

[cro789]

I have the Gradous in 308 and have over 2000 rounds through it in about 7 months and it still holds sub 1/2 groups when I do my part. When its time to replace it will be one of his barrels.

 

[beenjammin]

I sold the factory new Ax barrel when it came in without a shot fired because my older AW 1/12 shot so well. I say if it ain't broke, don't fix it.