Bullet pulling with the 338 Lapua

Silverbullet2

Gunny Sergeant
Full Member
Minuteman
Sep 20, 2009
1,017
10
Near Seattle, Wa.
Guy's,

I need to pull a bullet from a 338 Lapua, and the case will not fit into my knetic bullet puller. I was thinking I could hog out the inside of the puller, but the collet will not work either. So, is there a knetic bullet puller that will work with this caliber? Thanks, Jason
 
Re: Bullet pulling with the 338 Lapua

I just want to add Frankford Arsenal is too small for the 338LM casing to go through. However, I can collet the bullet and take 5 hits and it will loosen the bullet up to pull out by hand. After watching videos it seems the entire casing should fall in..Not going to happen on 338.
 
Re: Bullet pulling with the 338 Lapua

I just want to add Frankford Arsenal is too small for the 338LM casing to go through. However, I can collet the bullet and take 5 hits and it will loosen the bullet up to pull out by hand. After watching videos it seems the entire casing should fall in..Not going to happen on 338.