Hobby knee mill that has been converted to CNC. Does NOT have ball screws, but there are kits to convert these machines to ball screws. Controller has four Pacific Scientific 6410 stepper drivers. Fourth axis is the rotary table, but it has not been converted yet. Computer is included. Travel is X: 19 3/4" Y: 6 7/8" Z: 19 3/4" (CNC'd quill only travels ~4"). R8 Spindled. 1 HP motor. Runs off of 220V single phase, which can be wired into any garage (same voltage as a dryer). Original parts, spare part and a fluid pump are also included in addition to all of the accessories shown in the picture.
Have a special pallet the main body mounts on for moving it. Have moved it in the past using a truck/van with a lift gate and a pallet jack. Local pick-up in Cincinnati or buyer arranges shipping.
$4500
The equivalent machine at Grizzly without the CNC conversion or any of the accessories costs more.
Would consider partial trades for:
*Dillon RL-1100
*Vudoo V-22 22LR 22" MTU
*Nightforce ATACR 7-35x56 F1 Mil-XT
Have a special pallet the main body mounts on for moving it. Have moved it in the past using a truck/van with a lift gate and a pallet jack. Local pick-up in Cincinnati or buyer arranges shipping.
$4500
The equivalent machine at Grizzly without the CNC conversion or any of the accessories costs more.
Would consider partial trades for:
*Dillon RL-1100
*Vudoo V-22 22LR 22" MTU
*Nightforce ATACR 7-35x56 F1 Mil-XT
Last edited:
