Anybody out there had any experience with hydro-dipping? I found a company (mydipkit) that looks pretty promising-can I get some pictures/stories from anybody? Thanks...
-
Having trouble using the site?
Contact support
Hydro Dipping?
- Thread starter mhptrooper
- Start date
My dad had his 7wsm dipped... came out good. From these guys. Roberts Outdoor Hydrographics: Water Transfer Printing/Camo Dipping
haven't done it yet been watching youtube vids on how its done .i'm hoping to buy the same kit and try it out soon
I looked at just getting mine sent off to get done. It might be a little more expensive but those companies have everything to do it right and plenty of practice. Prices were pretty reasonable as well I think it was around 300-400 for a complete AR including scope and PRS stock.
we've done it a few times its not really to hard but there is a learning curve, depending on the pattern and how picky you are because there will always be a seam somewhere but for the most part its not rocket science.
How durable does this end up being? I don't use my rifles to hammer in tent stakes, but I don't burst into tears and run out of the woods if I bump a barrel into a tree trunk either.
Talked to someone today about this vs other methods. Their experience is that duracoat is much more durable.
Why not have the best of both worlds, they make a sealer for hydrodipped guns.
Manufacturer of DuraCoat Firearm Finishes: DuraClear Sealant
i had one done at ozarks hydrographics.. took some time to get it back though. it was covered with an automotive clear so it was pretty durable. this was on a target rifle, so i can't say how it would hold up banging around in the woods.
I've read that type of statement numerous times, and that because of the effort and materials that a beginner will use during the learning process, it's somewhat cost effective to have the film applied professionally if it's a one-time thing.
As for durability, there will be some spots and edges that get rubbed and show use, but the weapon itself remains protected. If you're looking for a showpiece that will see use in the field, the non-film coatings might be a better option. If you want effective camo and don't get bothered by signs of use, the film is a good choice. Wear signs can be touched up with a dab of paint, and this type of repair goes unnoticed on many camo patterns.
IIRC, contact with deet (found in many insect repellents) should be avoided with hydrofilm.
At this point, I haven't attempted application myself, but have a couple of rifles with hydrofilm. In one case, I sent my parts off. In another, I simply purchased furniture with the film.
Realtree AP Snow:
A-tacs AU:
