What chassis will this action drop in besides the MPA and the foundation stocks? I am looking for other alternatives.
Impact precision action
- Thread starter jaybigboy34
- Start date
I do not see why it would not fit, all these chassis fit 700 footprint actions, which the impact is
I had mine in a Magpul Pro 700 Chassis. Im very certain XLR would work too, if you tell them it's for an Impact. They can make almost anything fit if it doesn't already. MPA chassis fit as well.
BUT KRG chassis do not fit! The trigger hanger on the Impact is too big for any of the KRG chassis.
BUT KRG chassis do not fit! The trigger hanger on the Impact is too big for any of the KRG chassis.
My XLR needed I slight bit of inletting for the front trigger hanger screw head to clear. That said so did my Mcmillan A5 with CDI DBM. Not much on either, but still a little
Is that with the newer hanger screws or older? They reduced the size of the screw for that reason somewhere along the line
Mine is in a whiskey 3. I had to file a small amount off the aluminum trigger hanger on the action and replace one screw with a low profile one I slightly modified, but it wasnt too bad at all. The whiskey 3 has a screw right where the trigger hanger is, but most chassis and stocks do not have this same issue and require very minimal in letting by the front trigger hanger screw. I did this in a manners prs2 and it was like 2 minutes with a small file to make it work. It's really not a big deal at all. It's very little if any on nearly all of them. PM me if you need any specifics .
To add to @Moss Dynamics, i put my action into a xray chassis. Started a thread in the DIY section. Some filing on the chassis and low pro hanger screw did the trick
I bought mine as an action with barrel and trigger installed, it came with just the one hanger installed, no extra.
I bought an action and it only came with one. Im ok with it, got it in my krg xray and it fits fine after i modded it
My triggertech works on the 0 hanger, just wouldn't have minded a second. I just tried to stick my heavy palma impact action into a beragar hmr stock and its no bueno. The barrel channel is too small and I think the bolt release is interfering as well.
