I'm using a 5rnd AICS single stack magazine (Accurate) CIP length for 300WM in a Mcrees G10 chassis. Seems the belt on the top cartridge is grabbing the one beneath and shoving it forward. This causes the round(s) on the bottom to go tip down and move forward until the shoulders get caught in the stamping depressions.
Seems this would be a common problem with documemted solutions but I've found nothing. I thought about reducing spring pressure or rounding off the belt but this doesn't seem right. Any suggestions? Thanks in advance.
Seems this would be a common problem with documemted solutions but I've found nothing. I thought about reducing spring pressure or rounding off the belt but this doesn't seem right. Any suggestions? Thanks in advance.