Its tight as a nuns nasty, but the next time Im swapping barrels on the AT ill pop it out and show ya. Its the best of both worlds in reality - fully bedded, super tight, but removable for when my stupidity kicks in and I decide to change the color on the chassis.
I bonded my AX into its Vision but wish Id just bedded it too in hindsight.
Its tight as a nuns nasty, but the next time Im swapping barrels on the AT ill pop it out and show ya. Its the best of both worlds in reality - fully bedded, super tight, but removable for when my stupidity kicks in and I decide to change the color on the chassis.
I bonded my AX into its Vision but wish Id just bedded it too in hindsight.
Anyone have an ETA on the Vision butt stock in the US? Talked to GCP about a month ago and they said “supposedly” soon… Assuming the rear end will always require the AI hinge? I’m ready!
Zombie thread revived…
Dumb question, thumb hole stock with AX hinge, will the stock clear if bolt handle is rotated up? Just pondering
I have the AX hinge for a conversion, but need an AX stock, yet have the thumb hole stock…
In case anyone missed the first limited run and always kicked themselves for it, I'm selling my practically new in box pale brown (test fit with an action, but never bonded or fired)
I have a rare first run AO chassis for AI AT in Pale Brown that has only been test fit and never been bonded. Comes with epoxy kit, screws and bedding alignment screws, short bridge and rail and 2 internal weights (1 is 1lb and the other is 2lb) Asking $1105 shipped in CONUS PM if interested. Thanks