I used to live near Forest Grove, its gone downhill in recent years with the homeless. Now im between Scappoose and Vernonia. Scappoose isnt what it used to be either, the Portlanders decided they dont like the policies they voted for so they have been pushing out this way.
Match grade barrel fouling after 40rds?
- Thread starter AustinCar32
- Start date
It is possible your chamber neck dia is tight and the case neck clearance is minimal, causing the carbon build up to decrease the clearance even more. Can you drop/slide a bullet into a fired case neck? If you can, that isn't the problem. If you can't get a bullet in the fired case mouth, then there is your answer.
“
This finally dawned on me last night too. I had a tight necked BR that was similar one time. @AustinCar32 what is your OD of a loaded round case neck and another of your fire case neck?
Hmmm, im not home to measure the cases until this evening. Although, i have tried dropping a bullet into a fired case and it went in with ease. I have not tried dropping a bullet into a case that experienced over pressure though, so maybe i would get different results
On all peices of fired brass that have no pressure signs, the bullet drops right in like normal. All peices of brass showing even minor pressure signs, i have to push the bullet in and the bullet will stay in place even if i turn the brass upside down and shake it.
Got the borescope, heres what i see. First picture is the shoulder area inside the bore, second pic is just before the rifling, i think may be a carbon ring?
Got the borescope, heres what i see. First picture is the shoulder area inside the bore, second pic is just before the rifling, i think may be a carbon ring?
Attachments
Pic 1: So you got fire cracking, which means there’s been substantial heat with history of firing. This is not something in which to be alarmed with a high volume comp rifle, but a hunting rifle it’s insane. Don’t ask a tool to do two things equally as good.
Pic 2: Yup, carbon ring.
Pic 2: Yup, carbon ring.
The fire cracking probly wouldnt cause my problems, right? And im assuming the carbon ring is most likely my problem this whole time?
Some level of fire cracking would be expected. Not an expert on how quickly it occurs though.
Maybe I'm a bit dense, but I do not see any fire-cracking in pic 1. Which is good, because fire-cracking should not be present at the shoulder area.
What I do see in pic 1 is chatter and tool marks. Whoever chambered that rifle should be ashamed of himself.
What I do see in pic 1 is chatter and tool marks. Whoever chambered that rifle should be ashamed of himself.
Considering the case neck clearance is changing at a rapid pace, as evidenced by the difference in the case necks bullet test, just focus on keeping the carbon ring in check. Your case neck clearance has got to be too little. Neck turning the brass is the only way to increase that clearance without rechambering with a reamer with larger neck diameter.
Similar threads
