Official (DTA) SRS, HTI, Covert, Hunter Thread

[Andrews50]

I just got an HTI50 and mounted my scope on high rings (1.34"). I was able to get a decent cheek weld when I was initially getting a rough sight-in done from the prone position, but when I went to shoot it from the bench I noticed exactly what you described. I felt like I had to lay my temple flat on the cheek piece in order to just barely get any alignment. I read one of the replies below about rotating the rifle slightly toward me and aligning the scope with gravity as a workaround, but it just seems like for a $7k+ precision rifle, there has to be a better way. I'm looking at the eratac 1.85" mount thinking it might be high enough. Does anyone here have any experience with this? Or alternatively, has anyone come up with any other solutions?Thanks!

I added 2 scalarworks .69" risers to mine. It's a lot more ergonomic for me now. They are supposed to be coming out with a longer riser within the next month if they haven't already, it'll be the same height though.

 

[wooferocau]

Today I had a few individuals out for a shoot with the 375CT and my new "Blast Shields "
A few had never shot past 800yds!!

We shot from 1200 to 2000yds...
80 shots in total...

All thoroughly enjoyed it and were shocked how docile the Cheytac was !!
My added weights combined with the Shields make it an absolute joy to shoot ....thus the 80 rounds today..

 

[Dragoon300]

Here's my blast shield, mounted on my mule at a Vietnam vetrans get together.

 

[wooferocau]

320 rounds on new barrel.....already starting to firecrack...

 

[waveslayer]

320 rounds on new barrel.....already starting to firecrack...

It happens, what is it chambered in?

 

[wooferocau]

It happens, what is it chambered in?

375CT....
Not worried...my last factory barrel got 2440 rounds before i retired it..

 

[bmicek]

So what’s the best way to remove the little bit of creep in an A2 trigger? It’s not bad, but I notice it.