Does anyone load for the 460 S&W pistol?
I'm using Redding dies. Sizing die is adjusted per the instructions to touch the base plate on the Dillon 550.
Hornady's book calls for the OD of the case to be .478.
A once fired case measures .478.
A new unsized Starline case measures .4750 and drops into the cylinder perfectly.
I resized one new case and you can clearly see by the 'ring' left towards the base that it made it smaller. It now measures .469.
Does this seem normal and is this safe to use? See attached photo of the 'ring'. Case at the bottom is the resized one.
Also case length from the unsized to the sized went from 1.791 to 1.801
I'm using Redding dies. Sizing die is adjusted per the instructions to touch the base plate on the Dillon 550.
Hornady's book calls for the OD of the case to be .478.
A once fired case measures .478.
A new unsized Starline case measures .4750 and drops into the cylinder perfectly.
I resized one new case and you can clearly see by the 'ring' left towards the base that it made it smaller. It now measures .469.
Does this seem normal and is this safe to use? See attached photo of the 'ring'. Case at the bottom is the resized one.
Also case length from the unsized to the sized went from 1.791 to 1.801