Rifle Scopes Scope mount for AR15 with S&B 3-12
- Thread starter jp67
- Start date
Gdi makes nice mounts but expensive.
Nightforce unimount is another option.
Can't imagine cheaping out in a mount Fter buying that scope.
Nightforce unimount is another option.
Can't imagine cheaping out in a mount Fter buying that scope.
I like the jp mount. Pretty cheap, good lines. Alamo four star would be another good choice if you wanted qd.
$2k+ for an AR15 optic and a spuhr mount is too much money? By the time you buy a Larue mount at $210 you're halfway there and you get a conveniently placed bubble level plus all kinds of places to mount an ACI, mini red dot, light, laser, or a buttplug if you wish.
Badger AR Riser Rail (built in 22 MOA slope). Height of the riser rail is .430" Product # 248-25. Add any quality 34MM Rings that are 1" High, like Badgers Product # 306-14 or Nightforce #A208.
Nightforce also makes a nice one piece 34mm Unimount 1.44" High w/20 MOA slope Product # A257
Nightforce also makes a nice one piece 34mm Unimount 1.44" High w/20 MOA slope Product # A257
Did you even read the thread?
Badger makes a 1 piece in 30/34/35MM with built in slope.
Yes, I read the thread and your suggestion. Since you mentioned it I didn't think it would add value to mention it again. And since the pilgrim is on a budget, just maybe he has a set of 34mm rings of the right height that he can use on a Badger AR riser rail and save himself some money.
But of course once you posted your indisputable infinite wisdom, I guess the rest of us can just STFU, right??
I like the canted riser + ring arrangement too. I used a PRI 20MOA cantilever riser with Seekins rings to mount my 4-16 S&B on a 6XC AR10 and it worked great. With the riser+rings setup you can control your height by selecting your rings and you have more options on fore/aft positioning since the rings can be mounted anywhere on the riser and you don't have to worry about ring spacing limiting your options.
I suggested the ADM because I don't even consider it a quick release. By the time you have the clamps tight enough (for my comfort, at least) they're near impossible to get off by hand. I believe they're every bit as secure as a mount that is torqued on at that point.
Joe
Sent from my SAMSUNG-SGH-I777 using Tapatalk 2
Joe
Sent from my SAMSUNG-SGH-I777 using Tapatalk 2
I like Larue and Badger but they will not ship because I am abroad at the moment.
ADM seems to be willing to ship.
Regarding risers, it might work as I already have a set of badger rings but I would rather have a 1 piece canted mount.
Regarding QR: i do not mind.
ADM seems to be willing to ship.
Regarding risers, it might work as I already have a set of badger rings but I would rather have a 1 piece canted mount.
Regarding QR: i do not mind.
Last edited:
Similar threads
