Lots of people have asked for separate rings, but we have not had the time to make them before.
Here is a sample from first "zero" batch.
I am very greatfull to get in opinions about them.
Any options are very important so please let us hear.
The mount on the picture is 1" high and 30mm in diameter.
The rings are without any tilt and the length of the rings are 32mm/1,25" long.
Rear ring have two 5mm/.2" levels, so the ring can be mounted both for right and left hand shooters.
Plan is to start production now on 30 and 34mm, and at least to the beginning only in 1" height.
Here mounted with a Zeiss 6-24 on a Stiller TAC338 in .338 Norma mag.
Doctor sight mounted direct on our special Doctor footprint with a 12mm spacer in betwen to come above the knobs.
Two 5mm/.2" levels mounted in the rear ring to make left hand mounting possible. Model number always engraved in mount.
Trijicon RMR on direct footprint on the mount.
The screws attaching the mount to the rail is Torx.
All screws are stainless.
underside of mount showing integral recoillug machined in one piece with rest of the ring.
Number on the underside indicates when the mount is made and what batch.
What I would like to reicive opinions about.
Screws, allenhead screws doesent work on top rings as the small allen head screws will have the hole destroyed, therefor is torx screws a must.
Now we have also mmounted torx screws on the place where the mount attaches to the rail.
Good or bad? would others than Torx be preffered, if yes, why?
Other opinions?
For those of you that will visit shot show, please make a visit in TNVC booth at #6502 and see it for real.
Regards Håkan
Here is a sample from first "zero" batch.
I am very greatfull to get in opinions about them.
Any options are very important so please let us hear.
The mount on the picture is 1" high and 30mm in diameter.
The rings are without any tilt and the length of the rings are 32mm/1,25" long.
Rear ring have two 5mm/.2" levels, so the ring can be mounted both for right and left hand shooters.
Plan is to start production now on 30 and 34mm, and at least to the beginning only in 1" height.
Here mounted with a Zeiss 6-24 on a Stiller TAC338 in .338 Norma mag.
Doctor sight mounted direct on our special Doctor footprint with a 12mm spacer in betwen to come above the knobs.
Two 5mm/.2" levels mounted in the rear ring to make left hand mounting possible. Model number always engraved in mount.
Trijicon RMR on direct footprint on the mount.
The screws attaching the mount to the rail is Torx.
All screws are stainless.
underside of mount showing integral recoillug machined in one piece with rest of the ring.
Number on the underside indicates when the mount is made and what batch.
What I would like to reicive opinions about.
Screws, allenhead screws doesent work on top rings as the small allen head screws will have the hole destroyed, therefor is torx screws a must.
Now we have also mmounted torx screws on the place where the mount attaches to the rail.
Good or bad? would others than Torx be preffered, if yes, why?
Other opinions?
For those of you that will visit shot show, please make a visit in TNVC booth at #6502 and see it for real.
Regards Håkan
