• New Contest Starting Now! This Target Haunts Me

    Tell us about the one that got away, the flier that ruined your group, the zero that drifted, the shot you still see when you close your eyes. Winner will receive a free scope!

    Join contest

Suppressors Suppressor touching inside of Forearm, OK or NO?

ScottNC

Sergeant
Full Member
Minuteman
Apr 8, 2012
107
1
70
US
After learning a lot in the last few months from this forum and others, I figure some of you guys might be able to help me out with this.
I currently have an SBR build in the works and hope to have my stamps in the next 60 days. My current upper is a Yankee Hill A3 Receiver with a Yankee Hill Diamond Series Rifle Length Forearm, the barrel is a Daniel Defense 11.5" Mil Profile. The setup is designed to have my SAS M455 Suppressor fit approximately 2" into the Forearm, no problem so far, the forearm has an Inside Diameter of approximately 1.75" and the SAS M455 is OD 1.5". The question is that I'd like to switch the YH Forearm out for either a Spikes or Seekins SAR Forearm because I really prefer the slimmer profile, the new inside diameter of these two is real close to 1.5", the suppressor will just slide into these without force but it is very close and does touch the inside of the forearm slightly. Am I going to run into problems of any kind trying to accomplice this? It to me doesn't seem like it should create problems, I assume the forearm will get warmer than normal with the heat transfer from the suppressor, but this is a "for fun" plinker/target gun and I really don't do mag dumps...well not very often! Thanks in advance for any insight or thoughts on this you might be able to throw my way.
 
Re: Suppressor touching inside of Forearm, OK or NO?

It may or may not cause problems, if it is touching it may torque the barrel some. Just depends on how much its touching. It is yours you can do what you want with it, but if it was mine I would use a larger diameter tube. I did the same thing, but Im using the yankee hill tube.
 
Re: Suppressor touching inside of Forearm, OK or NO?

Glen, I have seen it, my current is a YHM and it too is 1.75" I'm trying to get into a smaller inside diameter if I can without it touching the suppressor. I just wrote to your CS this morning asking for an inside dimension on your SAR 12", that's what I'm really after but I'm afraid the 1.5" OD on my SAS M-455 won't go without contact, I know on Spikes SAR it touches, but fits. Might be I have to maybe machine 1/16 off the inside 2" of Forearm or just let it go and not change. If you happen to have that measurement on your SAR I'd be grateful. Thanks for your help, you build great products!
Scott
 
You must be at least 18 years of age to use this site
You confirm that you are at least 18 years of age by continuing to use the site.