Hey guys does anyone own one? I have a surgeon action and was hoping to run in it in a masterpiece arms Chassis. Thanks!
Switch lug updates?
- Thread starter Terryw123
- Start date
I don't have one but I also plan to build on one. Just be careful about action selection. If your action has an integral lug, like a Defiance Deviant or Bighorn TL3 for example, it will most likely not fit in the MPA chassis. I emailed them and they said their recoil pocket accepts up to like .375 inches or something like that. Which seemed odd to me, but that's what they said. So keep in mind, you may want to call em up just in case!
If your action doesn't have a integral lug, you should be good to go! I called West Texas Ordnance about em' and they've been having great success with it returning to zero, and being rock solid!
If your action doesn't have a integral lug, you should be good to go! I called West Texas Ordnance about em' and they've been having great success with it returning to zero, and being rock solid!
I have one - I had WTO build the rifle with a Switch Lug to make life easier once I need to replace barrels. So far, my only experience is with the single barrel, and I haven't removed it and remounted at this point. However, the gun's a tack driver - capable of sub 1/2 MOA all day long, if I'm not being an ass. No issues over 500 rounds. That's not exactly a torture test, or a long lifetime. But, take it for what it's worth.
Interested in possibly building one of these. Any idea if it'll fit in an aics ax type chassis?
Better to have it and not need it, than to not have it and say oh shit.....
Better to have it and not need it, than to not have it and say oh shit.....
I looked into using the switch lug on an AICS, and it would have taken a lot of work. You could only use an action that DOES NOT have an integral lug. And even at that, you would have to do quite a bit of grinding to the lug area on the chassis. I can't remember exactly what the thickness of the AICS lug area is, but it is smaller than .350".
Dang ok well there goes my idea for a poor mans axmc haha thanks
Better to have it and not need it, than to not have it and say oh shit.....
I'm not sure I'm seeing pictures of the new style AICS chassis, but on the old style, seems like opening the lug pocket would've been pretty short/simple work on a mill?
You've done it to the post 2014 chassis?
Better to have it and not need it, than to not have it and say oh shit.....
Has anybody tried this with using both long action and short action, like 300WM and .308/6.5 creed?
Better to have it and not need it, than to not have it and say oh shit.....
Better to have it and not need it, than to not have it and say oh shit.....
