Hello folks,
Encountered a strange issue today at the range, while zeroing at 100 yards, that has me a bit stumped. The rifle shot and zeroed without issue, but I was continually battling a strange phenomenon that I have never encountered before where, while the reticle would be sharply focused (properly adjusted the diopter***) , the target would drift in and out of focus. It honestly felt kind of psychedelic and had me wondering if my eyes were suddenly going bad. It happened a little more severely when at maximum magnification power.
My first thought was suppresssor mirage-effect, as the air temperatures were 50 degrees, and I do not have a suppressor wrap. I let the barrel cool but the issue would persist. I've read about issues with overtightened scope rings hindering the operation of the parallax/AO turret, but my scope rings were torqued to 18 in/lbs and the erector performed well on a tall-target test.
Can anybody think of what would suddenly be causing such an issue? I'm not sure if I have a warranty issue emerging or if there is something that I'm overlooking.
I've been shooting my current setup for a few years without issue: Remington 700 Tactical, Vortex Viper PST 6-24x50 FFP, Seekins Scope rings and a SilencerCo Omega suppressor.
Also, I do not wear glasses.
Thanks folks!
*** diopter was adjusted as instructed in Setting up a FFP rifle scope - A simple PSA on Diopters
Encountered a strange issue today at the range, while zeroing at 100 yards, that has me a bit stumped. The rifle shot and zeroed without issue, but I was continually battling a strange phenomenon that I have never encountered before where, while the reticle would be sharply focused (properly adjusted the diopter***) , the target would drift in and out of focus. It honestly felt kind of psychedelic and had me wondering if my eyes were suddenly going bad. It happened a little more severely when at maximum magnification power.
My first thought was suppresssor mirage-effect, as the air temperatures were 50 degrees, and I do not have a suppressor wrap. I let the barrel cool but the issue would persist. I've read about issues with overtightened scope rings hindering the operation of the parallax/AO turret, but my scope rings were torqued to 18 in/lbs and the erector performed well on a tall-target test.
Can anybody think of what would suddenly be causing such an issue? I'm not sure if I have a warranty issue emerging or if there is something that I'm overlooking.
I've been shooting my current setup for a few years without issue: Remington 700 Tactical, Vortex Viper PST 6-24x50 FFP, Seekins Scope rings and a SilencerCo Omega suppressor.
Also, I do not wear glasses.
Thanks folks!
*** diopter was adjusted as instructed in Setting up a FFP rifle scope - A simple PSA on Diopters
Last edited: