Rifle Scopes Vortex Violet gen2 zero stop

DunkinsDad

Private
Minuteman
Jan 2, 2019
14
3
I recently swapped back to my pst gen 2 and went to the range to zero it. Got it zeroed but at zero it’s up two full turns on the turret (see photo). I read Through the instructions and even watched some YouTube videos on setting the zero stop but I can’t get it to work. Anyone know how to reset the zero so it’s on target with the turret bs k down where it should be?
E4200DE7-60F1-4600-A52E-748F9B2E69A4.jpeg
 
Are the inside set screws turned all the way in? Have you loosened the outer set screws and then put the cap back on (may be tight, use some force - just don’t use a hammer ) then retighten set screws - o-ring seal makes it tight..
.