What’s wrong with this L3I elite magazine?

[BattleFieldDuke]

Heard a lot good words about the L3I elite magazines, bought 3 and tried the 1st one out, initially it won’t feed, bolt won’t catch ammo, noticed I could adjust depth, after adjustment, it started feeding, then started FTF, got the magazine out, found out that the spring stuck in the middle, follower is free floating as spring is stuck.

 

[BattleFieldDuke]

Thought it was a freak accident, I simply used a screwdriver to pluck the spring free and gave it another try.
Well sure enough, same thing happened again.

Anything I did wrong?

Only reason I got these magazines is because I heard they are superior to Vudoo factory magazines.
Well problem is all 5 of my factory polymer magazines have been working flawlessly, I thought I am getting a big upgrade with these elite magazines, oh well

 

[pronelife]

You're not alone, this vid kinda helped me but I won't use them in matches anymore.

 

[Buckhead]

Well, that is odd. Mine run flawlessly in both my Vudoos. Mavbe the spring is in upside down or something.
I have never had to pull one apart but it's fairly simple to pull the bottom off and see what is going on in there.

 

[hafejd30]

Without looking at one I’d guess it’s either 3D printed or molded. Likely a burr or it’s slightly cocked and hanging up. As mentioned pull the base off and check it out

 

[BattleFieldDuke]

You're not alone, this vid kinda helped me but I won't use them in matches anymore.

Thanks for confirming it’s not me. Yeah I know the loading technique for these 700 pattern Rimfire magazines, I actually was using those loading assist to load them one by one

 

[BattleFieldDuke]

Well, that is odd. Mine run flawlessly in both my Vudoos. Mavbe the spring is in upside down or something.
I have never had to pull one apart but it's fairly simple to pull the bottom off and see what is going on in there.

Just got them and this really doesn’t give me any confidence in them, might simply return them while I can, they only allow 7 days after receiving them for return. I would avoid taking them apart so I wouldn’t have any issues when returning them

 

[CroweMan]

I bought one last year and could not get it to run in my Vudoo or rimx. Reached out to L3i for customer support and never heard back…left a bad taste in my mouth.

 

[BattleFieldDuke]

I bought one last year and could not get it to run in my Vudoo or rimx. Reached out to L3i for customer support and never heard back…left a bad taste in my mouth.

Did you trying to adjust the insert depth? There is a screw on the magazine catch, you can adjust that to adjust insert depth. Mine wouldn’t feed at all initially as well. After the adjustment it would feed a few rounds then it would stop feeding because the spring would stuck

 

[CroweMan]

Did you trying to adjust the insert depth? There is a screw on the magazine catch, you can adjust that to adjust insert depth. Mine wouldn’t feed at all initially as well. After the adjustment it would feed a few rounds then it would stop feeding because the spring would stuck

Sure did. Looked at the follower spring as well as any signs of burrs or issues from the printing and couldn’t find anything wrong. Been wanting to try the new aluminum mag, but still on the fence.

Maybe I just got a bad one