Here is a video we shot here at the shop detailing the wild cat forming process. Should give you a good idea of the steps involved. It is important to note that no two wildcats are the same with regard to process. Enjoy!
WTC Wildcat Forming Demonstration
- Thread starter Dan Warner
- Start date
We will once we are a bit further along with the production. Please contact us directly if you are serious.
Not sure why but I can't see any video. I'm on Tapatalk but I can usually see any video posted. Can you post an HTML link?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
The brass looks annealed at the start. With all those forming steps, do you do any annealing during the process? That's one helluva press!
If I get serious about ELR again I certainly will. Yours is the only cartridge that peaks my interest at this point.
How's the load density, of what powder currently, and weight of, for the new 375 Wildcat?
https://www.youtube.com/watch?v=wdzqElkaN_o
There are several annealing steps that we chose not to include in the film. We made the press to suit our needs.
We are still experimenting with powers for that cartridge. Currently running 50BMG, but a little less than optimal because its not 100% full. Will disclose more on that once we get a little closer to that mark.
There are several annealing steps that we chose not to include in the film. We made the press to suit our needs.
We are still experimenting with powers for that cartridge. Currently running 50BMG, but a little less than optimal because its not 100% full. Will disclose more on that once we get a little closer to that mark.
