I'm getting started reloading 6.5 for PRS. I have a Co-Ax and need dies, I like the idea of micrometer dies as I work up my loads but I'm open to suggestions.
In Stock will also help
In Stock will also help
6.5 Creedmoor Dies
- Thread starter Overlord66
- Start date
If you're just getting started, take what you can get. My local Cabela's had ~6 of these in stock when I was there a couple of days ago. Hornady is more than good enough to get started. After the world settles down again, search out a set of Forster dies - a full length sizing die and a micrometer top, which will be 3x the cost of the Hornady.
Whidden Gunworks has their 6.5C bushing sizing die in stock or bundled with their seating die. It is a good choice.
I have a "Used a Couple of Times" Redding Competition set ... minus the Bullet Seating Die ... but the Micrometer Neck-Sizer and Body-Die are available. Photos below. If interested, PM me with an offer. They're just accumulating dust in my "Not Using" bin. You'd still need to find a Seating Die, but at least you'd be 2/3 there
careful you can get banned for this lowlight put the warning out that any sale outside of the px will get you banned. Im not trying to start shit I just didn't know if you where aware.
Go with a full length bushing type sizing die with bushings in the .287 to .290 range and a micrometer seating die. I would avoid neck sizing dies. You could try ebay if you don't find a set in the PX.
Short Action Customs is the bees knees if you have time to wait. I'm pretty sure Orkan's reviews have caused a huge demand for their dies.
https://www.snipershide.com/shootin...g-seating-dies-evaluation-discussion.7065752/
Short Action Customs is the bees knees if you have time to wait. I'm pretty sure Orkan's reviews have caused a huge demand for their dies.
https://www.snipershide.com/shootin...g-seating-dies-evaluation-discussion.7065752/
Wow ... didn't know that - was just trying to help. Seems that "Cancel Culture" had made it here. I'll be more careful.
Using the Redding set with the neck sizing die and the body die achieves the same results as a full length sizing die. It just adds an extra body die step for the batch that you are working on. The quickest way to have a ready to load case, of course, is to use a full length sizing S die with bushings as others have mentioned. I use one made by Redding for the 6.5 Creedmoor. I still run the case through two sizes of bushings...don't care about speed. After all brass is sized and clean, I then seat primers with a hand held priming tool from K&M...uses Lee shell holders. I don't like having to run the press ram to seat primers. I also place each case in a Wilson case gauge sitting on a flat surface. If it fits the gauge, it should fit your rifle chamber, and the gauge will indicate any growth in the length of the brass, too. A good caliper will become one of your most used tools. You'll have to do some internet research to find what's in stock.
Similar threads
