Does anyone have any experience with reloading once fired PPU (Prvi Partizan) brass? Specifically 6.5x55 Swedish caliber? Also any recommendations for or against any other makers? I am just getting started with this after nothing but 30-06 for many years.
-
Having trouble using the site?
Contact support
Any experience reloading PPU brass??
- Thread starter alfson
- Start date
I've loaded quite a bit of .338 Lapua mag and 7.5 Swiss brass. Its all been good and worked well. The .338LM brass seems to be pretty consistent though it has less capacity than the Lapua brass. The 7.5 Swiss brass works well in all the straight pull rifles. Its not a good idea to reload for the Stgw 57 so I haven't done that....
So far I've loaded the 338 cases up to 7 times with no issues and the 7.5 5 or so. I don't shoot the swiss rifles that much so they don't go through the brass.
Frank
So far I've loaded the 338 cases up to 7 times with no issues and the 7.5 5 or so. I don't shoot the swiss rifles that much so they don't go through the brass.
Frank
I've reloaded PPU (Privi Partisan) 7.62x54R, and it seemed to be fine stuff..
No experience with the 6.5x55 (but come to think of it, I think I have a box of that ammo someplace).
No experience with the 6.5x55 (but come to think of it, I think I have a box of that ammo someplace).
I have reloaded ppu for my 308 with good results. In my opinion the brass seems very soft. Sometimes it is difficult to eject a spent case after firing. It always produces accurate results though. It also lasts much longer than federal brass in my experience.
Sent from my HTCONE using Tapatalk 4 Beta
Sent from my HTCONE using Tapatalk 4 Beta
reloaded lots of 7.5 swiss a with very good results, their 6.5 grendel not so much, brass is way too thin
I've reloaded PPU 6.5x55. Got 3 loadings on it before buying Lapua for more precision. Worked ok, no failures. Not very consistent as far as weight or length, but all were useable. Accuracy was much better using Lapua brass. Annealing and prepping PPU brass may show you some benefit.
I have had no issues with their match ammo in 308, very consistent groups from a full case of ammo with every 20 round box with the same lot numbers, Reloading it has shown good case life with full length resizing and trimming it back. Primer pockets are still tight using CCI primers and I am sending a 168gr bullet at 2700fps for 1/4 moa at 100 yards. I just ordered 100 rounds of 338 Lapua brass and I am curious if it will hold up the same way.
I absolutely hate this ppu brass in 223 I've had about 3,000 pieces that wouldn't size properly. Of course every other manufacturer I've had no problems at all. I think it's very brittle brass seen the case head cracked once on the stamp end. I'd rather recycle this junk than fool with it what a nightmare it was. That's just my nightmare you may have a different opinion. Hate it yes sir it sucks for me Straight to the recycling box if it comes my way...
PPU brass is notorious for loose primer pockets after a few loads in 6.5 Grendel. If you can get it cheap enough, it's ok for plinking.
My ppu 308 has win on the case and seems good am nicking down for 6.5 an 243 for a mor ridged case
Similar threads
