• New Contest Starting Now! This Target Haunts Me

    Tell us about the one that got away, the flier that ruined your group, the zero that drifted, the shot you still see when you close your eyes. Winner will receive a free scope!

    Join contest

Coup De Grâce, New Action from American Rifle Company, $899 WOW!

question. is there a schematic or anything that show how an m5 bottom metal needs to be modified to allow the trigger hanger to clear?
No, but it’s not that hard. Wait until you get the action, pre-fit action to chassis and bottom metal. At that point you will see that there may or may not be a slight interference fit from the trigger hanger to the bottom metal. If so, Mark that area, remove a little bit of material from that area so the the action will fit without the trigger hanger rubbing on the bottom metal (use dremel or similar to remove material carefully).

Done.

If the above sounds too complicated and you are still unsure or confused, please take all components to a competent gunsmith or mildly capable handy person that you know and trust.
 
No, but it’s not that hard. Wait until you get the action, pre-fit action to chassis and bottom metal. At that point you will see that there may or may not be a slight interference fit from the trigger hanger to the bottom metal. If so, Mark that area, remove a little bit of material from that area so the the action will fit without the trigger hanger rubbing on the bottom metal (use dremel or similar to remove material carefully).

Done.

If the above sounds too complicated and you are still unsure or confused, please take all components to a competent gunsmith or mildly capable handy person that you know and trust.
thanks, that was my plan, but if there was info out there, well why not see what it says
 
You must be at least 18 years of age to use this site
You confirm that you are at least 18 years of age by continuing to use the site.