Gunsmithing Looking for someone to do a thread job

[bm11]

As the title states, I'm looking for someone to thread a barrel for me. It's a Green Mountain 10/22 barrel, I don't need it cut, just threaded with a thread protector for my Sparrow. I need someone who can do it quick (looking to get the gun up and running ASAP) and looking to spend as little as possible. I don't normally cheap out on work, but in this case where a new barrel can be had with threads and a thread protector for about $150, I'm going to have to be a bit stingy or I'll just buy a threaded barrel.

PM or post with the particulars if you want the job!

 

[Starbuck]

Re: Looking for someone to do a thread job

Call Adam at MHSA

 

[Switchbarrel]

Re: Looking for someone to do a thread job

I would check with Randy at Connecticut Precision Chambering. I've had him do three 10/22 trigger jobs and they've all been fantastic.

http://ct-precision.com/

-Rick

 

[ZY100]

Re: Looking for someone to do a thread job

ADCO for $65. Did my 10/22 for a sparrow and works like a champ...pretty quick turn, I think they had the barrel for about a week and a half.

ZY

http://www.adcofirearms.com/shopservices/shop_.cfm?code=1

 

[LRI]

Re: Looking for someone to do a thread job

96 hours.
$100/thread
$45/thread ring
??/shipping

C.

 

[Bill Larson]

Re: Looking for someone to do a thread job

at least 20$ 2 way ship.......1 hr. lathe time....unless a man will work for nothing.....
BUY NEW THREADED BARREL..........
OMHO
bill larson

 

[jbell]

Re: Looking for someone to do a thread job

Shoot it first with the new stock. Then if its still a hammer as you remember spend the money to have it threaded, keeping in mind not all barrels are created =. You may be able to spend the same ammount of $ on a prethreaded barrel but will it shoot as well??? It just may be worth the extra money in the end...

But then again you could get the prethreaded barrel for short change and it shoot better. This shit is fun, aint it

 

[Sonic Crack]

Re: Looking for someone to do a thread job

might as well just get a new barrel. my .02

 

[BoilerUP]

Re: Looking for someone to do a thread job

http://www.jpgrips.com/