Reloading Equipment Reducing Insert Set for your Auto Trickler

MDM

Sergeant
Full Member
Minuteman
Jan 26, 2009
717
75
Ohio
ATinsert4.jpg


Reducing Insert Set for your Auto Trickler - $20 shipped.

Not sure where my original thread went but I'm still getting PMs about the inserts for the Auto Trickler I've been making .

I've made a couple of different sized inserts that will be sold as a set. The inserts are a taper fit into your Auto trickler discharge tube. Just twist them in and go. There is a large ID and slightly smaller ID insert in the set. Some guys report they like the smaller insert and some like the larger best. You might find one insert works better for your particular powder, that’s why you get them both.

PM me if you want a set. Thanks.

atinsert1-jpg.1031636
atinsert3-jpg.1031637
atinsert4-jpg.1031638
 

Attachments

  • ATinsert5.jpg
    ATinsert5.jpg
    414 KB · Views: 236
Last edited:
  • Like
Reactions: Estes640
I make them for the Chargemaster as well.

 
I sent you a pm. I then saw the charge Master thread. My autotrickler underthrows because I over compensate to prevent overthrows.
I want some!!!!
 
These inserts are an important part of my charging process. Recently moved and couldn't find my inserts, decided to load my 100 rounds without the inserts.

My autotrickler kept overthrowing charges and it was driving me nuts. Put the reloading on hold until I found my inserts. Took some time, but I found them and its all good now. Finished my 100 rounds and only overthrew once! Can't recommend these enough!
 
I make them for the Chargemaster as well.

Still in business and making for chargemaster?
 
Only have v4. How does this work to reduce overthrows on v4 ?
From guys that have got back to me, it works the same as it always has, not as easy to install. It's still a tapered/slip fit, but just not as much room to get it in place. Its kind of difficult to get fingers and insert in the unit at the same time so you might have to get creative with some small needle nose pliers. This is what guys have told me, I don't have a v4 myself.