I did not get a response on the 6.8 Forum, so here goes.
I just received the adapter that screws into the can and allows to to be mounted on a threaded barrel. The instructions say to tighten to 35 ft lbs, but I don't see any way to hold the can to use the torque wrench on it without crushing the can. Is holding it and tightening it with the wrench as tight as I can get it enough. Also, does it screw in dry, oiled, anti-sieze, etc?
I just received the adapter that screws into the can and allows to to be mounted on a threaded barrel. The instructions say to tighten to 35 ft lbs, but I don't see any way to hold the can to use the torque wrench on it without crushing the can. Is holding it and tightening it with the wrench as tight as I can get it enough. Also, does it screw in dry, oiled, anti-sieze, etc?