Suppressors YHM Supressor Assy

[Rlandry]

I did not get a response on the 6.8 Forum, so here goes.

I just received the adapter that screws into the can and allows to to be mounted on a threaded barrel. The instructions say to tighten to 35 ft lbs, but I don't see any way to hold the can to use the torque wrench on it without crushing the can. Is holding it and tightening it with the wrench as tight as I can get it enough. Also, does it screw in dry, oiled, anti-sieze, etc?

 

[HansohnBrothers]

Use a Vox Block to hold the can in a vice. I recommend using a light amount of anti seize on the threads.
https://hansohnbrothers.com/shop/energetic-armament/accessories/tools/vox-blox/

 

[Rlandry]

That looks like a solution. Would I need the size that matched my can or the size smaller so that it would tighten when clamped in a vise?

 

[HansohnBrothers]

That looks like a solution. Would I need the size that matched my can or the size smaller so that it would tighten when clamped in a vise?

You’ll need the same size as your silencer.