Been thru two barrels with a 20lb Dasher for a prs rig. Second barrel isn’t toast but my brass is wore out and cracking in front of the case head. Bought a new round(600) of br brass and I’m having a hard time justifying the money for hydroforming or using my inventory of primers/powder to form cases. I’ve made the decision to purchase a reamer this go around and the dies aren’t a concern.
There is a run your loads slow and consistent wave going across the prs mainly with a group of very good shooters who promote watching trace/impacts and light recoil. My current setup(dasher) I’m running 109 hybrids at 2930. That’s where my node was after switching from 105’s which was around 2955.
I also have a 6gt 109’s at 2950 and 6creed fast as you want them in the stable if I need the speed. So maybe I am just jumping on the band wagon or looking for something to run in the 28xx’s and try to watch trace better.
Anyone have any real world results with bullet trace when dropping 100fps into the low 2800’s? What about wind at 900-1200 yards? Also concerned about the loss of target moving energy that guys running 223’s always complain about.
There is a run your loads slow and consistent wave going across the prs mainly with a group of very good shooters who promote watching trace/impacts and light recoil. My current setup(dasher) I’m running 109 hybrids at 2930. That’s where my node was after switching from 105’s which was around 2955.
I also have a 6gt 109’s at 2950 and 6creed fast as you want them in the stable if I need the speed. So maybe I am just jumping on the band wagon or looking for something to run in the 28xx’s and try to watch trace better.
Anyone have any real world results with bullet trace when dropping 100fps into the low 2800’s? What about wind at 900-1200 yards? Also concerned about the loss of target moving energy that guys running 223’s always complain about.