made this double burner setup outa some junk in the shop. works fairly well and cut my time in half. I use tempilaq for my setup and it doesn't take long "1,2,3 count " and done. works well but since its fast you need a solid count and pay attention the temp spec comes on Purdy quick, anyway heres a very short vid. I use a 60 psi regulator set to run at 40psi for a consistent pressure/flame and it runs off a
25#-100# tank. cord screwdriver and socket for consistent rotation of the case
the big square nuts have a bolt welded on one side to attach/adj.angle and the other side of the big square is drilled and tapped for the t-bolt to hold torch position.
I will have a Giraud one day....until then , this gets'r done Purdy dern quick.
VIDEO hillbilly annealer - YouTube
25#-100# tank. cord screwdriver and socket for consistent rotation of the case
the big square nuts have a bolt welded on one side to attach/adj.angle and the other side of the big square is drilled and tapped for the t-bolt to hold torch position.
I will have a Giraud one day....until then , this gets'r done Purdy dern quick.
VIDEO hillbilly annealer - YouTube
