The Dayton subs are made in Taiwan, not China.The morel 5.950 is a class AB on the front and rear channels, class D on the sub channel. Super nice amp for under $800. I don’t know the country of origin, but the quality and reputation sometimes count for something, so I wouldn’t worry about where it was made. I mean the Dayton subs that you like are for sure made in China, and for probably less than $40, so honestly I'm sure the morel amp is good even if made in China.
That’s all I got for you. Best of luck!
It's not much better, but it is better.
If you look at any audio product you'll find the caps, diodes, coils and inductors...etc etc are all made somewhere in Asia
If you're lucky it's Nichicon caps made in Japan.
If you're REALLY lucky it's Burr Brown op-amps made in the US.
And that's about it.
I think I have it nailed down to 2 amps now.
This Zapco..
Zapco ST-4X-SQ-III 4-Channel Full Range Class AB Amplifier
Zapco ST-4X-SQ-III 4-Channel Full Range Class AB Amplifier
www.woofersetc.com
And this Morel...
Morel MPS 4.400 4-Channel 400W RMS Class AB Amplifier
<ul> <li>4-channel car amplifier</li> <li>70 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)</li> <li>200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)</li> <li>Class AB amp technology</li> <li>100 dB signal-to-noise ra
www.woofersetc.com
You too huh ?I'm currently doing a build on my 2011 Suburban. (OK, I'm currently driving around without a driver's side door panel waiting for the inspiration to get back to my install)