-
Having trouble using the site?
Post any issues in the thread below or reach out directly to support!
Contact support
Unfortunately, that's me bombing that (and most of) the stages.
Yes I took the dremel to the underside of the diving board. It was a learning experience as my first dremel project but it worksDid you shave down the reptilia diving board to fit the GII razor objective bell?
Made a first round impact at 1000yds but I knew better than to try and follow it up.
Attachments
Amazing rifle, where did you get that very nice barrel decal ?
The rust is. Thick. $75 308 barrel was doing well till the 5th shot.
My AXSR’s participation trophy for taking second at a pistol match. And by participation, I mean participating in being home during the UPS delivery guy’s visit after getting home from the match. Time to see what all the hubbub is about.
I did
I’m in my sleep around phase right now…have to pick a partner before I bust out the rattle cans in December.
Nothing against it. Was trying to sell it to buy and try the SB636 with the TR2ID, but a guy on here offered this as a 1:1 trade so I said sure.
Just bouncing around scopes before picking one to live on the AXSR before I paint it.
Yeah, just wow!
@M8541Reaper I’m testing the SB 6-36x TR2ID tomorrow after getting it back from repair. As-delivered it had a serious parallax binding issue, but I think it’s going to be GTG now.
Interesting. Why? I only have the 7-35 ATACR, several SB 5-25s, and the new SB 6-36 to compare. And because this is a picture thread, AXMC 300NM with the SB 6-36 TR2ID (one of the first with the new reticle).
Last edited:
Pic tax for those hurt by my words and non-picture actions here tonight.
Looks like you didn’t make any compromises… not even zero of them.
What reticle you go with?
No paint=low social credit
Gen3XR Fine
It’s ok, I’m going to buy the spray paint with my Star Card. Guaranteed social credit boost. It’s got the points cards crave!
What are your thoughts on the TR2ID? I plan to have my 6-36 swapped to that reticle eventually.
So far I like it, but I’ve only had one session with it at distance. It’s a good “sparse” tree reticle. I just shoot ELR at my own range, no comps. I only need the tree for when I run out of Elevation on the turret and need to hold over AND hold some wind. I have a Tremor 3, but it is sooo busy it is hard to spot misses. I also have a Mil-XT which I like a lot. This is very similar. I don’t know how it would be for comps, but for me I think it’s perfect. (WAAAY better than the P5FL with not enough info, and the GR2ID that looked even busier than the Tremor3 to me).
Last edited:
How many S&Bs will Dr Strangeglove buy this year?
Comp shooters , if you switch to upgraded followers. Keep an old mag around. Can only fit 10 in the new style. 11 in the ole style helps on the 12 round stages.
Last edited:
Give it a year, Magpul will release 50rd AICS and 100rd AXSR/MC drums
Well…it went 4,287rds in AZ meth dust before it went down. I should have not been an asshole and just flushed it each time I tore it down rather than just hitting it with a brush. Popped the spare in and got back to work.
#SparePartsSavedTheDayThePawPatrolWay
#DontNeglectYourTriggersNeeds
#MissingButLookingCoolIsBetterThanMissingAndLookinLikeATool
By went down do you mean it wouldn’t reset? Wouldn’t fire? Was firing without pulling the trigger? Was first or second sear out of adjustment? Working fine after hosing it out with some liquid?
As in it wouldn’t recock the firing pin when closing the bolt. Nothing was adjusted on the trigger so it still sits adjusted as it came. Going to buy some brake cleaner and compressed air but it worked for a few cycles after a light fluid flush but then it stopped again. I’m not worried, just going to give it a good cleaning and blow out tonight.
Lighter fluid, brake cleaner etc all work fine. Seen a couple that had to be opened up completely...
Give me a 3 pos safety and an og trigger everytime baby
Almost time to get a ZCO on my AT-X, and put old glory back on the AT. Never thought I’d have one AI let alone 2.
Meet the Barrett Mk22, brought to you by AI's un-neccessary trigger-fiddling experiments.
Last edited:
Didn't realize you were at that match, it was a fun one despite the target failures.
What reticle is that?
Good. I've found it sad that the AT has been sitting in the closet untouched...
Yes. Target indicators on the bars would have been nice also. I was mostly punishing berms but was nice to get to a match
MR2. In my spotter. Ffp. I like it to measure targets / misses and “pre shoot” stages
And in case anyone didn’t look close and thought we were shooting full size ipsc lol.
Beautiful set you have!!
Trying to decide currently if I’m going to multicam my ATX (elite sand currently) or trade it out for another AT/thumbhole
