Thanks for that.
This is were I saw the difference, if you look at the shape of their Gen2 lug it's oval.
tikkaperformance.com
All good man.This is were I saw the difference, if you look at the shape of their Gen2 lug it's oval.
Tikka T3/T3x Gen2 Performance Series Picatinny Rail - Mountain Tactical Company
Specifications:
I haven't personally measured one, though I've seen a picture of someone's rail lug that deformed the receiver lug recess.
Regarding Mountain Tactical, I tired to do business with them but gave up after 2 email attempts with no reply and 2 or 3 phone calls during their limited business hours with no answer. Your results may vary.
Tough one, sold my Range Rover and lost all interest in cars... until I came across that 130 Defender. I just love it.
Yes 100% correct. When I re-barreled my Ruger Precision, I used a dead-blow hammer on the barrel nut wrench to give it that sharp impact to break it loose. I tried to apply torque by hand and and that wasn't doing shit. 2 whacks with a dead-blow and done.
The chap in the pictures is a customer and friend... I took the pictures and we also made the stock. He was involved in the development of the heavy duty bipod /tripod range with Rob from Spartan as well as writing for gun magazines. We had also flush fitted a universal adapter into that stock just in front of the floor plate. Javelin/spartan 300 or tripod can fit into that.
How do you like that bolt handle over the stock handle? Easier to operate?
I like it for sure, and yes it is easier to operate by a bunch, but it might be a little over sized. I think something in the middle of what is on my rifle and what comes stock would be ideal. It is just a little long when it comes to throwing the rifle in a pack or something similar. It can get caught pretty easy.
He goes by the handle @cannoncrossfire here. Send him a PM and ask him yourself.
I've used the standard .300 WM AICS mags in the past with the .284 Win without issue (5 rounds go in); I prefer the double stack mag when I can get it, which is the only reason that I'm considering the TRG-mag version. If they tell me that it's a non-starter, then I will go with the AICS version or something equivalent.They do have both short action and long action setups for the Tikka T3 / T3x which use AICS magazines (not sure which magazine is most compatible with the .284 Winchester, though).
I just ordered a few myself
I think you mean a mill setup not lathe. The easiest way to remember is by thinking of whether the part spins (lathe) or the tool spins (mill). Thinking of a Tikka stock spinning in a lathe is scary.
That's fine. Most people aren't. That's why we try to educate.Wrong choice of words, not familiar with machining
Does this mount work on the Krg backbone? Anyone have pics?Do you have picture of your rig with TRG bipod on it?
I would love to see a picture of that.
I bought Atlas TRG bipod mount, because i got it so cheap.
Thinking to make it to my Bravo, so i dont need to buy that little bit expensive spigot mount for my chassis.
I might need to do some modification on the chassis, but it should fit there.
This is the mount.
We fit Atlasworx mag systems almost daily however 300wm T3 AI type less than 10%. The T3 is a bit tight for the AI 300WM mag, some say mill 2mm off the trigger housing but we found that is not needed. Recently a picture was posted on this thread where the front bottom of the action had a V cut-out which could make good sense for longer loaded cartridges. I have not tried that yet.
