I love my AT. The only reason at this time i could possibly think as to why i might move it on is because i want to get another Long Action Rifle for some ELR at some point in the future... to save on buying two lots of glass, i might consider selling the AT and buying a MC... maybe.
Keep the AT and save for the MC. You’ll be thankful later in. One of the guys in here has the exact setup @hafejd30
I've got the flat shoe here, been sitting on it for about 6 months... Don't want to pull the rifle apart to put it in. Being lazy... Even considered shortening the flat blade to slip it in, still assembled.
Thanks man, I didn’t want to pull it apart either. But @TheGrabiod gave me some advice after I already did. But I think it would work if you slide the stock trigger shoe forward. Then pull the trigger and can use something to keep the trigger in the “fired” position then slide the old shoe off and new shoe on. Or you can curse the rear action bolt to death like I did until I found a 5/32 ball head driver.I've got the flat shoe here, been sitting on it for about 6 months... Don't want to pull the rifle apart to put it in. Being lazy... Even considered shortening the flat blade to slip it in, still assembled.
Good looking rifle.
Yes I recall being told the same. But if finances dictate and the ELR itch grows, I may not have a choice.
Mine was getting very tough to run in a match with cold , rain and snow.
if I have a shitty day at least i know 75+ dudes were checking me out.......And we all know that the most contributing factor to skill is looking good
The Fix It Sticks extended ball but worked for me. But yea they are hard to find…and fuck that location.I love my AXSR with all my heart, but why in god's name did they put the rear receiver bolt directly under the mag catch?? The only ball end I've found that can actually get to it is a allen wrench, and I want a 1/4" bit extension but can't find one with enough approach angle. I really don't want to knock the mag catch out every time I want to check torque.
It's a rhetorical question, they did it that way because that's the way the geometry worked out, I know.
Pic because this is a pic thread.
View attachment 8055558
Those mag catch pins are directional also. So something to keep in mind before hammering em out and messing up the holes. And that mag catch sucks to put back in. Best to just get a quality extened ball head.I love my AXSR with all my heart, but why in god's name did they put the rear receiver bolt directly under the mag catch?? The only ball end I've found that can actually get to it is a allen wrench, and I want a 1/4" bit extension but can't find one with enough approach angle. I really don't want to knock the mag catch out every time I want to check torque.
It's a rhetorical question, they did it that way because that's the way the geometry worked out, I know.
Pic because this is a pic thread.
View attachment 8055558
Weirdly, I prefer using the MC in comps compared to the AT but both will do just fine!
Nice one cheers.Weirdly, I prefer using the MC in comps compared to the AT but both will do just fine!
@JayjayUK you can try my MC at Bisley or one of the PRS shoots and see for yourself
[I appreciate the sin of using a Harris on any AI, I have repented]
View attachment 8053929
View attachment 8053930
This AT is the one rifle I’ll never sell. No plans to sell the MC either but it comes down to it the AT still is king in this castle
Save for the MC or SRView attachment 8053934View attachment 8053935View attachment 8053936
Looking to get a gen3 razor for my AT. What height spur is that? Will 1.18” clear?Nothing wrong with a Vortex on an AI
This is the one on mine...But it is on a AI 20 degree rail.
